Using Console Commands › Console Commands › RELOAD=TEP Command-Reload TBETEP Global Module

RELOAD=TEP Command-Reload TBETEP Global Module

Use the RELOAD=TEP command to reload the TBETEP global module. This module includes the CA Tape Encryption open, close, and end-of-volume routines, which are shared by all BES address spaces.

This command loads the open, close, and end-of-volume routines from the STEPLIB defined to the BES task that the command is issued against. If no STEPLIB is defined to the task, the TBETEP module is loaded from the CA Tape Encryption data set in the linklist.

Important! Use caution when issuing this command. It impacts every BES task on the system where you issue it. The best practice is to test new versions of TBETEP on a separate test system.

Note: For information about test systems, Recommendations for Test Environments.

This command has the following format:

BESn RELOAD=TEP

n

Indicates the BES task number.

Limits: If you are using your security system to control access to commands, all forms of this command can be controlled by a command protection profile.

Example: RELOAD=TEP command

This example loads the open, close, and end-of-volume routines from the STEPLIB for task BES2.

BES2 RELOAD=TEP