Using Console Commands › Console Commands › RELOAD=COMPRESSION Command-Reload Compression Modules and Tables

RELOAD=COMPRESSION Command-Reload Compression Modules and Tables

Use the RELOAD=COMPRESSION command to load new versions of load modules for compression attributes. This command reloads and refreshes all resident compression modules and compression tables. Old versions of these modules and tables are deleted when this command is run. The addresses of any current versions of these modules and tables are saved in the addresses of the old versions. New versions of the modules and tables are loaded and stored at the addresses where current versions had been located. The RELOAD=COMPRESSION command must be issued for each active BES task on the system.

This command has the following format:

BESn RELOAD=COMPRESSION

n

Indicates the BES task number.

Limits: If you are using your security system to control access to commands, all forms of this command can be controlled by a command protection profile.

EXAMPLE: RELOAD=COMPRESSION command

This example reloads the software and hardware compression tables for BES1.

BES1 RELOAD=COMPRESSION  

BES1X0103I Command Accepted                         
BES1D0451I BES Compression routines reloaded        
BES1D0452I BES Software compression tables reloaded 
BES1D0453I BES Hardware compression tables reloaded 
BES1X0100I Command Complete