Previous Topic: How to Configure Any Web Agent in Unattended Mode

Next Topic: Run an Unattended Configuration

Prepare an Unattended Configuration

Unattended configuration uses the ca-wa-installer.properties file to propagate the Web Agent configuration set up across all Agents in your network. For configuration, you define configuration parameters in the properties file, then copy the file to any web server in your network to run an unattended configuration.

When you perform an initial Web Agent installation and configuration, the ca-wa-installer.properties file is installed in the following location:

web_agent_home/install_config_info

The default parameters and paths in the file reflect the information you entered during the initial Web Agent installation and configuration.

To make the ca-wa-installer.properties file available on your system

  1. Run an initial installation of the Web Agent.
  2. Open the ca-wa-installer.properties file and, if necessary, modify the configuration parameters.
  3. Save the file.

More Information

Install a Web Agent on a UNIX System

Install a Web Agent on a Windows System


Copyright © 2010 CA. All rights reserved. Email CA about this topic