Administration Guide › Configuring Resources › Configure CA Network Automation › Configure the CA Network Automation Server

Configure the CA Network Automation Server

To run Network Automation scripts from CA Server Automation, configure one CA Network Automation server for use with CA Server Automation.

Follow these steps:

1. Open the CA Server Automation user interface.
2. In Management mode, click Administration, Configuration.
3. In the Network/Storage section, click Network Automation Server.
4. Click + (Add) and provide the following information:

   Server Name

   Specifies the name or IP address of the CA Network Automation server.

   User Name

   Specifies the user name for the CA Network Automation server.

   Password

   Specifies the password for the CA Network Automation server user.

   Protocol

   Specifies the protocol used to access the CA Network Automation server.

   Default: HTTP

   Port

   Specifies the port number used by the CA Network Automation server.

5. Click OK.

   The CA Network Automation server is configured.