Use the Local 3270 Device Interface › Start a Session when TSO and VTAM are Inactive

Previous Topic: Use the Local 3270 Device Interface

Next Topic: START SYSVLCL—Invoke SYSVLCL PROC

Start a Session when TSO and VTAM are Inactive

Use the local 3270 device interface of CA SYSVIEW to run the product in a dedicated mode from any locally attached 3270 device.

Use this interface to start a session with CA SYSVIEW even when TSO and VTAM are not active. Also use this interface when JES2 is not active.

Follow these steps:

  1. Copy the SYSVLCL procedure from the sysview.SAMPJCL data set into SYS1.PROCLIB.
  2. Specify SUB=MSTR on the START command as described in the next section.

The TSO session starts.