Implementing EventView Rule Sets › Change the EventView Rule Set Associated with a Local System Image

Change the EventView Rule Set Associated with a Local System Image

You can change the EventView rule set associated with a local system image. Update the EventView Ruleset to Activate field on the System Image Definition panel.

Note: The associated rule set is activated when the system image is loaded initially. If you change the rule set associated with the system image later, you do not have to reload the system image. The rule set takes effect immediately when the system image definition is saved.

To change the EventView rule set associated with a local system image

1. Enter /RADMIN.I.L at the prompt.

   The Local System Image List appears.

2. Enter U (Update) next to the system image that you want to update.

   The Local System Image Definition panel appears.

3. Enter the new EventView rule set name in the EventView Ruleset to Activate field.

   Note: You can select an EventView rule set from the prompted field value list.

4. Press F3 (File).

   The updated record is saved.

   Note: By default, EventView rule actions are not executed if the system image is operating in the MANUAL global operation mode. The actions, however, can be enabled by using the Perform Action in Manual Mode? field of the AUTOIDS region parameter group.