Installing Your Product from Tape › Install the Software in an SMP/E Environment

Install the Software in an SMP/E Environment

During the installation process, you provide the site-specific installation information that you previously collected. This information is used to generate the installation JCL jobs.

The installation process creates the dsnpref.LX10.INSTDB database to store details of each installation that you perform. These details include the installation values that you specify.

Follow these steps:

1. At the ISPF/PDF TSO Command Shell prompt, execute the following command:

   EXEC 'dsnpref.LX10.CC2DJCL(INSTALL)'
   

   The Install Utility panel appears.

   Note: On each of the Install Utility panels, you can use the following keys:

   • Enter to proceed to the next panel
   • F1 to display online help
   • F3 to return to the previous panel
   • F4 to exit and return to the main menu
2. Press Enter.

   The Install Utility Primary Menu panel appears.

3. Enter 1.

   The Parameters Primary Menu panel appears.

4. Enter A to start the parameter review process.

   The first of a sequence of Parameters panels appears.

5. Complete each of the panels as they open. Press Enter at the completion of each panel. You can take the default options or specify site-specific values.
6. Enter 2 to start the installation process.

   The INSTALLATION Primary Menu panel appears.

7. Enter 1.

   The installation software generates a series of jobs in the dsnpref.LX10.CNTL JCL data set.

   Note: Jobs can be submitted from the panel or directly from this data set after exiting the panel.

8. Submit and run the following installation jobs in sequence. Do not proceed with any job until the previous job has completed successfully.

   Each job should return condition code 0 unless otherwise indicated.

   I01ALLOC

   Allocates the data sets.

   The I01ALLOC member allocates CC2DLOAD as a load library of the PDS type. Do not change it to a PDS/E type because the type is not supported.

   I02INSMP

   Initializes the SMP/E data sets.

   I03RCSMP

   Performs an SMP/E RECEIVE.

   I04AKSMP

   (Optional) Performs an SMP/E APPLY CHECK.

   I05RSSMP

   Performs an SMP/E RESTORE. This job is provided as a sample.

   I06APSMP

   Performs an SMP/E APPLY.

   I07ACSMP

   Performs an SMP/E ACCEPT.

9. Press F3.

   You are returned to the Primary Menu panel.