Installing Your Product from Tape › How to Install Products Using Native SMP/E JCL › Prepare the SMP/E Environment for Tape Installation

Prepare the SMP/E Environment for Tape Installation

The members used in this procedure prepare the data sets, initialize the zones, and create the DDDEFs for CA SMF Director.

For information about the members, see the comments in the JCL.

To prepare the SMP/E environment for your product

1. Customize the macro ASFSEDIT with your site-specific information and then copy the macro to your SYSPROC location. Replace the rightmost parameters for each ISREDIT CHANGE macro command. Each time you edit an installation member, type ASFSEDIT on the TSO command line, and press Enter to replace the defaults with your specifications.

   The macro is ready to customize your ASF.SAMPJCL members.

   Note: The following steps include instructions to execute the ASFSEDIT macro each time you open a new SAMPJCL member. To edit all SAMPJCL members simultaneously, read and follow the instructions in the ASFEDALL member.

2. Open the SAMPJCL member ASF1ALL in an edit session and execute the ASFSEDIT macro from the command line.

   ASF1ALL is customized.

3. Submit ASF1ALL.

   This job produces the following results:

   • The target and distribution data sets for CA SMF Director are created.
   • Unique SMPLTS, SMPMTS, SMPSCDS, and SMPSTS data sets for this target zone are created.
4. Open the SAMPJCL member ASF2CSI in an edit session and execute the ASFSEDIT macro from the command line.

   ASF2CSI is customized.

5. Submit ASF2CSI.

   This job produces the following results:

   • The CSI data set is defined.
   • The SMPPTS and SMPLOG data sets are allocated.
   • The global, target, and distribution zones are initialized.
   • The DDDEF entries for your product are created.
   • The DDDEFs for the required SMP/E data sets are created.