OPSVIEW Control Option › How to View SSMGA Resources Information (Option 4.11.G) › How to Enter Filter Criteria on the SSM Resource Status Panel › Primary Commands for the SSMGA Resource Status Panel

Primary Commands for the SSMGA Resource Status Panel

There are a few primary commands you can issue from the SSMGA Resource Status panel. Enter primary commands in the Command field.

AUTO nn

Places the panel in automatic refresh mode. The value of nn indicates how many seconds CA OPS/MVS waits before refreshing the panel. The minimum value of nn is 5; the maximum is 600.

Default: 60 seconds

Typically, you should place the panel in automatic refresh mode only if you set the View field to EXC. To exit from automatic refresh mode, press the ATTENTION key.

CANcel

Ignores any updates or line commands entered on the panel and reconstructs the display with the current resource data.

FILter

Displays the SSMGA Resource Filters panel to change the filter values that limit which resources are displayed. You can also invoke this command by placing the cursor under the Filtered field near the top of the panel and pressing Enter.

VERGBL

Validates resource synchronization of the GST with the LST on each system in the SSMGA complex. Also validates the SSMGA resource content of each LST. VERGBL can be run on any system. However, if not run on the SSMGA GLOBAL system, it can only validate systems connected to the current system.

VERMOV

Diagnoses any problems with movable resources. Also identifies any outstanding SSMGA WTORs that should be responded to. VERMOV can be run on any system. However, for faster performance it should be run on the SSMGA global system.

VERSYS sysname.subsys

Validates the SSMGA setup. The sysname.subsys value indicates the SSMGA system on which to run the validation. A value of * in the first position indicates local/current system. A value of * in the second position indicates local/current subsystem.

Default: *.*