OPSVIEW OPSLOG Option › How to View a List of All Possible OPSLOG Columns › Primary Commands for the OPSLOG Browse Column Selection Panel

Primary Commands for the OPSLOG Browse Column Selection Panel

The following are the primary commands you may use on the OPSLOG Browse Column Selection panel. Issue primary commands from the Command field:

CANcel

Cancels your changes and returns you to the primary OPSLOG Browse panel.

SORT

Sorts the column selection list by column name (NAME, COL, COLUMN, or COLNAME), column length (LEN), current display position (POS), or the original default (DEFAULT).

For example, suppose you specify this command:

SORT LEN NAME

As a result, CA OPS/MVS sorts the column selection list first by the length of each column and then by the column name. This sort sequence is not only useful for users viewing the selection list, but also helps CA OPS/MVS to determine relative column positions when the same value has been placed in multiple Pos fields. You may specify up to four column values for the SORT command. The NAME and DEFAULT columns have unique values.

WIDTH

Causes the current total width of the selected columns to appear. This value is important, because although you may select up to 14 extra columns of information for display on the OPSLOG Browse panel, the total width of those columns must be small enough to permit at least 10 characters of the event text to be visible on the panel. By issuing this command, you can determine whether you have selected too many columns before CA OPS/MVS issues an error message.