OPSVIEW Control Option › How to Modify the Value of a Subnode › Display Global Variables-Modify Value Using the Line Command Panel

Display Global Variables-Modify Value Using the Line Command Panel

If you enter the M line command on the Display Global Variables panel, the system displays the Display Global Variables-Modify Value Through Line Command panel. You can modify the entire variable value from this panel. Following is a sample panel:

AOF CTRL - Display Global Variables -------- MSI1 ------------ Subsystem OPSS
COMMAND ===>                                                 SCROLL ===> PAGE
Global variable: GLOBAL.NEWNODE
Modify the Global Variable by typing over the data below (length: 1000   )
----+----1----+----2----+----3----+----4----+----5----+----6----+----7----+---
123456789012345678901234567890123456789012345678901234567890123456789012345678
123456789012345678901234567890123456789012345678901234567890123456789012345678
123456789012345678901234567890123456789012345678901234567890123456789012345678
123456789012345678901234567890123456789012345678901234567890123456789012345678
123456789012345678901234567890123456789012345678901234567890123456789012345678
123456789012345678901234567890123456789012345678901234567890123456789012345678
123456789012345678901234567890123456789012345678901234567890123456789012345678
123456789012345678901234567890123456789012345678901234567890123456789012345678
123456789012345678901234567890123456789012345678901234567890123456789012345678
123456789012345678901234567890123456789012345678901234567890123456789012345678
123456789012345678901234567890123456789012345678901234567890123456789012345678
123456789012345678901234567890123456789012345678901234567890123456789012345678
12345678901234567890123456789012345678901

From the previous panel you can either:

• Enter the CANCEL command to cancel the modification.
• Type the desired variable value over the value that appears on the panel. Then enter the END command to put the change into effect.