OPSVIEW Control Option › How to Control the Multi-System Facility (Option 4.2) › Line Commands for the Multi-System Facility Panel

Line Commands for the Multi-System Facility Panel

CA OPS/MVS provides the following command options for you to use to control your MSF sessions. To use one of these command options, enter it in the Sel field on the line where the desired session appears.

A

Activates the session.

D

Deletes the session.

H

Displays the meaning of the VTAM return code that appears in the VTAM RTNCD field on the panel.

I

Inactivates the session.

R

Restart the local and all defined remote systems.

S

Causes an MSF System Status Panel describing the remote system to appear. For details about the panel, see The Multi-System Facility System Status Panel in this chapter.

Point-and-shoot is enabled to obtain status information for a remote system. To obtain status information for a remote system using the point-and-shoot method, place the cursor in the SEL column for the remote system and press Enter. Point-and-shoot is enabled only if no primary or line commands have been entered.