Manage the Processors › OPSHMC Parameters › Additional Parameters

Additional Parameters

Depending on the command you want to issue, you will be required to enter additional parameters.

• For the CPC and LPAR Activate actions:

  ActivationProfile-The name of the activation profile that you want to use to activate the CPC. If you want to use the default value, you can specify ActivationProfile().

• For the CPC and LPAR GetAttribute and SetAttribute actions:

  Attribute-The name of the attribute that you want to get or set the value for.

• For the CPC and LPAR SetAttribute actions:

  Value-The value to be assigned to the attribute.

• For CPC Activate_OOCOD action:

  OrderNumber-The order number of the On/Off on Demand (On/Off CoD) record to be activated.

• For all LPAR actions:

  LPAR-The name of the LPAR on which you want to work.

• For the LPAR Load action:

  ClearMemory(YES|NO)-Specifies whether to clear memory before performing the Load action. There is no default.

  LoadAddress-The hexadecimal address to be used when performing the Load action. The default value is the last address used when a Load action was performed for the object. To use the default value, specify LoadAddress().

  LoadParm-The parameter string to be used when performing the Load action. The default value is the last parameter used when a Load action was performed for the object. To use the default value, specify LoadParm().

  StoreStatus(YES|NO)-Specifies whether the status should be stored before performing the Load action. There is no default.

  Timeout-The amount of time (in seconds) to wait for the Load action to complete. There is no default

• For the LPAR Send_Opsys action:

  OpCommand-Specifies the operator command that you want to issue on the LPAR. Sending a blank OpCommand parameter repeats the previously sent command.

  Priority(YES|NO)-Specifies whether the command is a priority operating system command. There is no default.