Configuring and Installing Optional Components › Tasks for Separately Licensed Components › Install OPSLOG Webview Components

Install OPSLOG Webview Components

The OPSLOG WebView components must be installed to run both the client and server sides of OPSLOG WebView.

To install the OPSLOG WebView components

1. Modify the INSTSMPW JCL member in hlq.OPS.SAMPJCL to meet your local standards. To do this, perform the following steps.
   1. Customize the job card.
   2. Designate the USS/HFS or zFS in compatibility mode destination path where you plan to install the OPSLOG WebView server files

      Note: See Resource 3 in the Resource Checklist.

   3. Set the DLIBPFX and associated unit, volume, and SMS parameters to the same values used in the INSTSMP1 job for SMP/E target libraries.
   4. Provide the prefix of the SMP/E GLOBAL.CSI data set.
2. Submit INSTSMPW JCL to batch.

   The SMP report output should show that the new function has been applied, and accepted. When the job completes, the web-related files required to run OPSLOG WebView will have been installed.

   Note: To avoid problems accessing the files installed on your web server, set the permissions for these files to 644 (octal). This setting grants read permission to everyone; however, update permission is granted only to the file owner.