Starting Your Product › Configuration Tasks for the Base Component › Add Command Processors in LPA with ISPF

Previous Topic: Replace ASVT Entries

Next Topic: Other Command Processor Considerations

Add Command Processors in LPA with ISPF

If you run CA OPS/MVS out of LPA and you use ISPF, you must add the names of the CA OPS/MVS command processors to the ISPF TSO command table module.

To add the names of the command processors

  1. Review the sample in member OPISPTCM of the SYS1.OPS.CNTL data set of the modifications that you need to make to ISPTCM.

    For details about adding names to ISPTCM, see your ISPF installation guide.

  2. Enter the names in the ISPTCM module, which contains a list of TSO command names.

    The modifications to this table module are complete.

  3. Reassemble it and link it into an appropriate load library.

    The command processors are added.

More information:

Provide a CA ACF2 Command Limiting List