Shut Down Resources in a Loaded System Image

Controlling the System Image › Shut Down Resources in a Loaded System Image

You can use the following commands to shut down the resources defined to a loaded system image:

Note: This procedure is valid only if the global operation mode is set to AUTOMATED.

To shut down resources that are in an operation mode of AUTOMATED

Enter SHUTSYS at the prompt on the status monitor.
If the region is linked to other regions, the Execute SHUTSYS Command panel appears listing the loaded system images in all linked regions. Go to Step 2.

If the region is a standalone region, the Command Confirmation panel appears. Go to Step 3.
Enter S beside the system image you want to shut down.
The Command Confirmation panel appears.

Important! Issuing the SHUTSYS command shuts down all resources that are in the AUTOMATED mode.
Enter CONFIRM in the Response field.
All automated resources defined to the system image are shut down.

To shut down resources that are in the MANUAL operation mode, do one of the following:

Enter MA beside the resource to change its operation mode from MANUAL to AUTOMATED before issuing the SHUTSYS command.
Enter T beside the resource to stop it manually.

Note: This command is valid only if the global operation mode is set to AUTOMATED.

To shut down all resources in a system image

Enter SHUTFORCE at the prompt on the status monitor.
If the region is linked to other regions, the Execute SHUTFORCE Command panel appears listing the loaded system images in all linked regions. Go to Step 2.

If the region is standalone region, the Command Confirmation panel appears. Go to Step 3.
Enter S beside the system image you want to shut down.
The Command Confirmation panel appears.
Enter CONFIRM in the Response field.
The resources defined to the system image are shut down.