Analyzing Monitor Data › Interactive Analysis Option 3 - CodeView › Display the Program Listing

Previous Topic: Display CSECT Activity Locations

Next Topic: Display Delay Location Information

Display the Program Listing

If the program you are analyzing has been registered with CA Mainframe Application Tuner, you can display the program listing at the module/CSECT. To view the program listing, type L and press Enter. The program listing displays in ISPF Browse mode.

The program must be registered with CA Mainframe Application Tuner to view the listings. If you keep your program listings in PROTSYM or CA Endevor with footprinting enabled, CA Mainframe Application Tuner can register these listings automatically, using dynamic registration support. For more information, see the Installation Guide, "Customization", under the section heading Set Up Profile Parameters.

TUNCOB01 listing

000155         011600*--------------------------------------------------------
000156         011700*   INSPECT AGAIN                                       
000157         011800*--------------------------------------------------------
000158         011900                                                        
000159         011910  INSPECT1-100.                                         
000160         012000     MOVE    "EVEN MORE DATA FOR THE INSPECT TO DO" TO DA
000161         012100     INSPECT DATA-CONST2 TALLYING COUNT-03 FOR CHARACTERS
000162         012200      AFTER INITIAL "E" REPLACING ALL "O" BY "Z".       
000163         014910                                                        
000164         015100  STOP-100.                                             
000165         015200     CLOSE BIGBLOCK.                                    
000166         015300     CLOSE UNBLOCK.  
000167         015400     STOP RUN.