|
|
|
Use the State input field to filter the jobs to be displayed by state, for example, display only job steps with State = OPEN.
The SORT primary command can be used to change the order in which the information is listed. For details about how to use the SORT command, see Sort List Panels.
Line commands can be used to work with a specific job step that is displayed in the list.
Displays an overview of job information, see Job Overview.
Displays an overview of stored measurements, see Measurement Overview.
Displays the information about an alert, see Total Alert Text.
Displays an overview of all alerts, see Alert Overview.
Opens an alert with reason code CHCK. An alert confirmation window is displayed.
Displays the results based on your selection criteria for these fields.
Displays the most recent occurrence date taken from SMF or, if not available, the first date detected by the job library scan (APCBAJCL).
Indicates whether DB2 processing was used during the job step execution.
Displays the actual number of average seconds between checkpoint writing.
Displays the actual number of checkpoint writes during step execution.
Displays the actual average elapsed time in minutes.
Displays the actual average service units consumed in
Displays an identifier that represents the importance of a checkpoint.
This number is a number from 0 to 50 where 0 is least important. The importance indicates how the consumption of a particular job step is ranked in regards to consumption of computer center performance.
Indicates the alert state of the job step. All possible alert states are listed and described in the table in the section Alert Management.
| Copyright © 2011 CA. All rights reserved. | Tell Technical Publications how we can improve this information |