CA MII Statements and Commands › (MII) EDITEST Command-Display EDIF Processing Options

(MII) EDITEST Command-Display EDIF Processing Options

The EDITEST command lets you display the EDIF processing options that are in effect for a specific data set. This command is available only when you are running the EDIF of the CA MII component.

Scope: Local

This command has the following format:

EDITEST [DATASET=dsname]
        [DSORG=organization]

DATASET

(Optional) Identifies the data set for which you want information. Specify the dsname of this data set in place of the dsname variable.

You can use the abbreviation DSNAME for this operand.

DSORG

(Optional) Identifies the data set organization of the data set for which you want information. Specify this operand only if a DSORG statement in the EDIPARMS member affects this data set.

Specify one of these values in place of the organization variable:

• DIRECT (or DA)
• ISAM
• (PARTITIONED (or PO)
• SEQUENTIAL (or PS)
• UNMOVABLE-PARTITIONED (or POU)
• UNMOVABLE-SEQUENTIAL (or PSU)
• VSAM

Usage Notes: EDITEST Command

• The EDITEST command can be specified in the MIMCMNDS or MIMSYNCH member of the MIMPARMS data set. When you specify this command in the MIMCMNDS member and the TRACE feature is active, the output is sent to the MIM trace data set. When you specify this command in the MIMSYNCH member, the output is sent to the system log.
• You also can issue the EDITEST command from any console or TSO session.
• EDIF displays processing information in message MIM4063.
• Defaults for most EDIF statements, when not specified, depend on how they are used with other statements.

  Note: For more information, see the chapter “Advanced Topics” in the CA MII Programming Guide.

Example: EDITEST Command

To see what processing options are in effect for the SYS1.LOAD data set (when you have specified a DSORG statement for partitioned data sets), issue this command:

EDITEST DATASET=SYS1.LOAD DSORG=PO