Planning Initial Settings › Planning the MIMCMNDS Member
Planning the MIMCMNDS Member
The MIMCMNDS member of the CA MIM parameter data set contains commands that specify operating values for CA MIM. The commands specific to CA MIC do the following:
- Manage cross-system messages traffic. Use the COLLECT command.
- Create, modify, and delete linkages that enable consoles, products, internal and instream command sources, and TSO users on the local system to issue commands to any system. Use the LINK command.
- Set values for the collection of statistical records. Use the following parameters:
- SETOPTION GCMF STATCOLLECT
- SETOPTION GCMF STATCYCLE
- SETOPTION GCMF STATINTERVAL
- Obtain diagnostic information. See the section Activating Tracing in the chapter “Advanced Topics” in this guide. Use the following parameters:
- SETOPTION GCMF RESETPRINT
- SETOPTION GCMF RESETTRACE
- SETOPTION ICMF RESETPRINT
- SETOPTION ICMF RESETTRACE
- SETOPTION GCMF SETPRINT
- SETOPTION GCMF SETTRACE
- SETOPTION ICMF SETPRINT
- SETOPTION ICMF SETTRACE
- Set operating values for the GCMF. Use the following parameters:
- SETOPTION GCMF ACTIONCODE
- SETOPTION GCMF ACTIONPREFIX
- SETOPTION GCMF AUTODELETE
- SETOPTION GCMF BROADCAST
- SETOPTION GCMF BUFLIMIT
- SETOPTION GCMF CAPTURELOG
- SETOPTION GCMF CART
- SETOPTION GCMF COLORSUPP
- SETOPTION GCMF DELETE
- SETOPTION GCMF DELETEINTERVAL
- SETOPTION GCMF EXCLUDEJOB
- SETOPTION GCMF EXCLUDEPREFIX
- SETOPTION GCMF GCMDUMP
- SETOPTION GCMF GCMRETRY
- SETOPTION GCMF MAXCONS
- SETOPTION GCMF MINCONS
- SETOPTION GCMF MSGFILTER
- SETOPTION GCMF SAFSYSTEMS
- SETOPTION GCMF SYSLOG
- Set operating values for the ICMF. Use the following parameter:
- SETOPTION ICMF AUTOIDEFSYS
