Installing Your Product from Tape › How to Install Products Using Native SMP/E JCL › Prepare the SMP/E Environment for Tape Installation

Prepare the SMP/E Environment for Tape Installation

The members used in this procedure prepare the data sets, initialize the zones, and create the DDDEFs for CA MIM.

For information about the members, see the comments in the JCL.

Follow these steps:

1. Customize the macro BTDSEDIT with your site-specific information and then copy the macro to your SYSPROC location. Replace the rightmost parameters for each ISREDIT CHANGE macro command. Each time you edit an installation member, type BTDSEDIT on the TSO command line, and press Enter to replace the defaults with your specifications.

   The macro is ready to customize your BTD.SAMPJCL members.

   Note: The following steps include instructions to execute the BTDSEDIT macro each time you open a new SAMPJCL member. To edit all SAMPJCL members simultaneously, read and follow the instructions in the BTDEDALL member.

2. Open the SAMPJCL member BTD1ALL in an edit session and execute the BTDSEDIT macro from the command line.

   BTD1ALL is customized.

3. Submit BTD1ALL.

   This job produces the following results:

   • The target and distribution data sets for CA MIM are created.
   • Unique SMPLTS, SMPMTS, SMPSCDS, and SMPSTS data sets for this target zone are created.
4. Open the SAMPJCL member BTD2CSI in an edit session and execute the BTDSEDIT macro from the command line.

   BTD2CSI is customized.

5. Submit BTD2CSI.

   This job produces the following results:

   • The CSI data set is defined.
   • The SMPPTS and SMPLOG data sets are allocated.
   • The global, target, and distribution zones are initialized.
   • The DDDEF entries for your product are created.
   • The DDDEFs for the required SMP/E data sets are created.