XCF Return Codes

CA MIM for z/OS Abend and Return Codes › XCF Return Codes

XCF Return Codes

CA MIM uses the CA XCF Standard Component (LXCF) to enable operation of the z/OS Cross-System Coupling Facility (XCF) for cross‑system communication. This section contains a listing of the XCF return codes. If the information provided for a return code is not sufficient to correct a problem, then contact CA Technical Support.

Verb	Code	Description

DEREGISTER	00	LXCF DEREGISTER was successful.
	28	LXCF is not initialized.
	2C	LXCF could not obtain storage for control blocks.
	30	MEMBERTOKEN does not identify a registered member.
	Any other value in register 15 indicates that the IXCLEAVE macro completed with a non-zero return code. Register 15 contains the return code from IXCLEAVE, and register 0 contains the reason code for IXCLEAVE.
ENDEVENT	00	LXCF ENDEVENT was successful.
	28	LXCF is not initialized.
	2C	LXCF could not obtain storage for control blocks.
GETEVENT	00	LXCF GETEVENT was successful.
	04	No events are queued for member.
	28	LXCF is not initialized.
	2C	LXCF could not obtain storage for control blocks.
	30	MEMBERTOKEN does not identify a registered member.
INITIALIZE	00	LXCF INITIALIZE was successful.
	04	Caller is running on an unsupported operating system.
	08	Caller is not in supervisor state.
QUERYACTIVITY	00	LXCF QUERYACTIVITY was successful.
QUERYSTATUS	00	LXCF QUERYSTATUS was successful.
REGISTER	00	LXCF REGISTER was successful.
	28	LXCF is not initialized.
	2C	LXCF could not obtain storage for control blocks.
	30	Member subtask could not be attached.
	34	Member subtask terminated during initialization.
	Any other value in register 15 indicates that the IXCJOIN macro completed with a non-zero return code. Register 15 contains the return code from IXCJOIN, and register 0 contains the reason code for IXCJOIN.
SENDMSG	00	LXCF SENDMSG was successful; message was accepted for delivery.
	40	LXCF is not initialized.
	44	LXCF could not obtain storage for control blocks.
	48	MEMBERTOKEN does not identify a registered member.
	Any other value in register 15 indicates that the IXCMSGO macro completed with a non-zero return code. Register 15 contains the return code from IXCMSGO, and register 0 contains the reason code for IXCMSGO.
TERMINATE	00	LXCF TERMINATE was successful.
	28	LXCF is not initialized.
	2C	LXCF could not obtain storage for control blocks.

Tell Technical Publications how we can improve this information