Messages › CA MIM Messages › MIM0390W

MIM0390W

no response to {CTC|XCF} communication on path address to system sysid

Reason:

CA MIM has attempted to communicate using the CTC or XCF method over the specified path, but the target system has not responded for one of the following reasons:

• An I/O error occurred on the device
• Incorrect configuration information was given
• CA MIM has terminated on that system (due to a command or an abend)
• There are system problems

This message is issued only when the target system has responded to a communication on at least one other path. The message is issued periodically, with the frequency determined by the time set on the SETOPTION MARGIN command.

Action:

If you are running with COMMUNICATION=CTCDASD or CTCONLY, then check the configuration on the CTCPATH statements for the indicated CTC path. The path must be defined on both systems to provide complete communication. If an error is found, then correct the CTCPATH statements and restart CA MIM.

If the indicated system is experiencing problems, or CA MIM will not be started on that system for an extended time, or both, then issue the FREE command to free that system. If there is a problem with the CTC path, and it will not be recovered for an extended period, then issue the DEALLOCATE command to deallocate the CTC device, allowing CA MIM to continue without it.