Messages › CA MIM Messages › MIM0300I

MIM0300I

Checkpoint File Status

Id    Volser   Status   Format-Action
nn    volser   status   action

Reason:

This message is issued during initialization and after the selection of an active checkpoint file. The following information is displayed:

ID

Indicates the checkpoint file ID, which is the last two digits of the checkpoint file data set name.

Volser

Indicates the volume serial number of the device on which this checkpoint file resides.

Status

Indicates the status of the checkpoint file. One of these values is shown in place of the status variable:

ERROR

Indicates that the control file is unusable because CA MIM experienced an I/O error when accessing it. You can clear the error status by specifying FORMAT=CHKPT or FORMAT=BOTH.

IN-USE

Indicates that this is the current checkpoint file.

USABLE

Indicates that this is a usable alternate checkpoint file.

Format-Action

Indicates whether the checkpoint file was formatted or will be formatted during the synchronization process. One of these values is shown in place of the action variable:

FORMATTED ON REQUEST

Indicates that this checkpoint file was formatted because you specified FORMAT=CHKPT or FORMAT=BOTH.

FORMATTED ON ERROR

Indicates that this checkpoint file was found to be unsuitable for the configuration and has been formatted.

SCHEDULED FOR FORMAT

Indicates that this checkpoint file had been used as an active checkpoint file in the past, but has been selected as the active file because a more recently active file was found. This file will be reformatted during synchronization.