Appendix C. WEB LOG EXTRACTOR (WLE) OVERVIEW › C.5 WLE Remote Setup › C.5.1 Installing WLE Utility in a Remote Site

C.5.1 Installing WLE Utility in a Remote Site

This procedure is ONLY for installing WLE at a remote site (a
site that is not running CA MICS).  If you are installing WLE
in a CA MICS system, you MUST use the checklist in Section
C.2 of this guide.

The primary purpose of installing this utility in a remote
site is to provide a way to collect the data generated by
servers that are not accessible to the CA MICS system.

Data generated by running WLE utility at the remote site must
be transported to the host for processing by CA MICS Web
Analyzer.

The WLETAR tar file can be transmitted to another site using
a utility such as FTP and uncompressed (inflated), using the
tar command at the remote location where the WLETAR is
transmitted and stored.  The file is found in
sharedprefix.MICS.BIN(WLETAR).

The tar command syntax shown below to uncompress WLETAR must
be executed in a UNIX System Services shell session:

tar -xvof WLETAR

There are three files that are extracted from the WLETAR tar
file by the above command:  wleload.exe, wleload.conf, and
wleload.scp.

This completes the WLE utility remote installation.