7. PARAMETERS › 7.3 Unit Level Parameters › 7.3.1 Processing Options (RMFOPS)

7.3.1 Processing Options (RMFOPS)

This section shows you how to specify the operational
statements that control CA MICS Hardware and SCP Analyzer
processing.

Operational statements are stored in the prefix.MICS.PARMS
cccOPS member, where ccc is the component identifier, and are
incorporated into the CA MICS system by running the
prefix.MICS.CNTL(cccPGEN) job.

*************************************************************
*                                                           *
*  NOTE:  CHANGES to prefix.MICS.PARMS(cccOPS) members      *
*         REQUIRE EXECUTION of prefix.MICS.CNTL(cccPGEN)    *
*         to take effect.                                   *
*                                                           *
*         In addition, any change to parameters that        *
*         impact the DAILY operational job JCL such as,     *
*                                                           *
*         o  changing RESTART NO to RESTART YES,            *
*                                                           *
*         o  WORK parameter changes when RESTART NO is in   *
*            effect,                                        *
*                                                           *
*         o  Specifying TAPEfff (if this product supports   *
*            a DETAIL level TAPE option),                   *
*                                                           *
*         o  or changes to prefix.MICS.PARMS(INPUTccc),     *
*                                                           *
*         will require regeneration of the DAILY job by     *
*         executing prefix.MICS.CNTL(JCLGEND) or by         *
*         specifying DAILY in prefix.MICS.PARMS(JCLGENU)    *
*         and executing prefix.MICS.CNTL(JCLGENU).          *
*                                                           *
*         Refer to the checklist (if provided) for updating *
*         cccOPS parameters and running required generation *
*         jobs.                                             *
*************************************************************

You must include at least one OPTIONS statement that provide
additional control information for the analyzer. There are
also additional optional statements supported that provide
the means to customize the analyzer's behavior to meet your
data center requirements.



Required Statement
------------------
OPTIONS statements

Optional Statements
-------------------
WORK, MULTWORK, and NOMULT statements
Internal Step Restart statements
Incremental Update statements

The worksheet in Figure 7-2 helps you collect the data needed
to complete prefix.MICS.PARMS(RMFOPS).  As with most CA MICS
PARMS members, the parameters are free-form, but positional.
Comments are coded by beginning the statement with an
asterisk (*).  Blank statements are allowed.

The following sections explain each of the option statements
specified in prefix.MICS.PARMS(RMFOPS).

    1 - OPTIONS Statements
    2 - WORK, MULTWORK, and NOMULT Statements
    3 - Internal Step Restart Statements
    4 - Incremental Update Statements