Installation Guide › JBoss Version › Single Node Installation › How to Perform a Single Node Installation › Configure IPv6 Support

Configure IPv6 Support

If you are installing on a IPv6 supported JBoss system, some configuration is required.

Follow these steps:

1. Open the run.bat/sh file located in jboss_installation\bin.
2. Uncomment one of the following properties in the IDM_OPTS entry:
   • For IPv6 only systems, uncomment the following entry:

     #IDM_OPTS="$IDM_OPTS -Djava.net.preferIPv6Addresses=true"
     

   • For IPv6/IPv4 systems, uncomment the following entry:

     #IDM_OPTS="$IDM_OPTS -Djava.net.preferIPv4Stack=true"
     

     Note: These properties are shown for UNIX; however, they are the same as found after a REM in Windows.

3. Save the file.