Federation Manager Guide › Federation Manager Installation › Unattended Federation Manager Configuration › Run the Unattended Configuration

Previous Topic: Set Up the Configuration Properties File

Next Topic: Log in to the Federation Manager User Interface

Run the Unattended Configuration

You can configure Federation Manager without any user intervention.

Note: You must have previously configured a system manually to create the ca-Federation-config.properties file. You can modify this file to suit your network.

To run an unattended Federation Manager configuration

  1. From a system where Federation Manager is already installed, copy the following two files to a temporary location:
  2. Run the following command from where you copied the installation and properties files:

    configuration_executable -f ca-Federation-config.properties -i silent

    The configuration starts in unattended mode, using the parameters in the properties file for settings.

  3. On Windows, reboot the system after the configuration is complete.

    Note: To verify an unattended installation on Windows review the installation log file CA_Federation_Manager_InstallLog.log, which is located in the directory federation_mgr_home\install_config_info.