Federation Manager Guide › Federation Manager Installation › Unattended Federation Manager Installation › Run the Unattended Federation Manager Installation

Previous Topic: Set up the Installation Properties File

Next Topic: Unattended Federation Manager Configuration

Run the Unattended Federation Manager Installation

You can run an unattended installation to install Federation Manager without any user intervention.

Note: You should have already run a manual installation to create a ca-Federation-installer.properties file. This file is required for running an unattended installation on another system. You can modify this file as needed for your installation.

To run an unattended Federation Manager installation

  1. From a system where Federation Manager is already installed, copy the following two files to a temporary location:
  2. Run the following command from where you copied the installation and properties files:

    installation_executable -f ca-Federation-installer.properties -i silent

The installation starts in unattended mode and uses the parameters in the properties file to install Federation Manager.

Note: To verify an unattended installation on Windows review the installation log file CA_Federation_Manager_InstallLog.log, which is located in the directory federation_mgr_home\install_config_info.