Federation Manager Guide › Load Balancing Support for Federation Manager › How to Configure Load Balancing › Configure the Load Balancer

Previous Topic: How to Configure Load Balancing

Next Topic: Set up the Federation Manager Systems to Work with a Load Balancer

Configure the Load Balancer

Configure the load balancer to work in a network with Federation Manager. Redirects to all resources on Federation Manager use the load balancer host and port.

Note: This procedure assumes that the administrator of the load balancer knows how to set up the system in the deployment.

To set up the load balancer

  1. Configure the load balancer to map IP addresses and host names for the Federation Manager deployment.
  2. Configure the load balancer for the Federation Manager deployment, making sure to pass the following URLs through to the Federation Manager systems:

    These URLs enable the load balancer to balance traffic between the Federation Manager systems.

  3. (Optional) Configure the load balancer to handle SSL traffic.

    If the load balancer is SSL-enabled, all federation traffic comes in to the load balancer over SSL. However, the load balancer sends the traffic to the Federation Manager systems over a non-SSL (HTTP) connection.

The load balancer is now configured to work with Federation Manager systems.