Agent Installation › Installing an Agent on Solaris Systems › Maintaining Agents › Troubleshooting Agent Installation

Troubleshooting Agent Installation

Occasionally, process binding does not take place as expected. Use the following procedure to diagnose this error and take corrective action.

To diagnose and correct a bind failure

1. Log on to the Solaris host as root.
2. Change directories to the agent root directory, /opt/CA/ELMAgent.
3. Type the following command:

   ps - eaf|grep caelm
   

4. Examine the displayed results.
   • A successful bind results in a display similar to the following example. Here, the caelmwatchdog process ID 27773 successfully binds with the caelmagent process ID 27771. A successful bind starts the agent service.

     root 27773 27771   0 18:11:12 ?           0:00 ./caelmwatchdog
     root 27771     1   0 18:11:07 ?           0:02 ./caelmagent -b
     root 27793 26155   0 18:14:22 pts/1       0:00 grep caelm
     root 27772 27771   0 18:11:07 ?           0:00 ./caelmdispatcher
     

   • An unsuccessful bind results in a display similar to the following example. Here, the caelmwatchdog and caelmagent process IDs are not displayed and the agent service is not started.

     root 28386 26155   0 18:56:18 pts/1       0:00 grep caelm
     root 28300     1   0 18:51:39 ?           0:01 ./caelmdispatcher
     

     Note: If the caelmwatchdog binding to the caelmagent did not take place, kill the caelmdispatcher and start the agent service manually.

5. If you determine that the agent start was unsuccessful, do the following:
   1. To kill the caelmdispatcher, enter kill -9 <caelmdispatcher process ID>, for example:

      kill -9 28300
      

   2. Change directories to /opt/CA/ELMAgent/bin.
   3. Start the CA Enterprise Log Manager agent service.

      ./S99elmagent start
      

      The message "CA ELM Agent Started Successfully" appears.

Note: View the agent status details again and verify that the agent is Running.