Administration Guide › Integrations and Connectors › How to Create an Integration › Set TIBCO Configurations

Set TIBCO Configurations

You can control data access settings for integrations using the TIBCO sensor. You can use the CA-provided default settings for most event collection purposes, but you may want to alter these settings for custom integrations.

To set TIBCO configurations

1. Open the integration wizard, select the TIBCO Log Sensor, and advance to the Default Configurations step.
2. Set or edit the following master configuration values to identify and access the event source you want:

• TIBCO Server

  Specifies the name or IP address of the TIBCO server in the following format:

  Protocol://server IP or name:Port number
  

  For example, when installing the CA Access Control Report Server you specify whether you want to communicate using SSL. Based on your response, specify one of the following:

  • If you do not select SSL, specify the following value:

    tcp://tibcoTCPsrv:7222
    

    Replace "tibcoTCPsrv" with the name or IP address of your TCP server.

  • If you select SSL, specify the following value:

    ssl://tibcoSSLsrv:7243
    

    Replace "tibcoSSLsrv" with the name or IP address of your TCP server.

    The port value, 7243 is the default. If you specified a different value when you installed the Report Server, you must use that port value.

• TIBCO User

  Specifies the user name for TIBCO server authentication.

  For example, when installing the CA Access Control Report Server you specify whether you want to communicate using SSL. Based on your response, specify one of the following:

  • If you do not select SSL, there is no default and you can specify any user name.
  • If you select SSL, specify "reportserver".
• TIBCO Password

  Specifies the password for TIBCO server authentication.

  For example, when installing the CA Access Control Report Server you specify whether you want to communicate using SSL. Based on your response, specify one of the following:

  • If you do not select SSL, there is no default and you can specify any password.
  • If you select SSL, specify the password you entered when asked during the report server installation.
• Event Log Name

  Specifies the log name for the event source.

• PollInterval

  Specifies the number of seconds the agent waits before polling events when the TIBCO server has become unavailable or disconnected.

• SourceName

  Specifies the identifier for the TIBCO queue.

• TIBCO Queue

  Specifies the name of the TIBCO queue from which the log sensor is to read messages (events).

• Number of Collection threads

  Specifies the number of threads to be spawned by the log sensor to read TIBCO queue messages. The minimum value is 1. The maximum number of threads that can be spawned is 20.