CA EEM Getting Started › Configuring Failover › Artifact Federation › Enable Artifact Federation

Enable Artifact Federation

If you want to use artifacts federation, perform the following procedure on all CA EEM Servers in a failover setup.

Enable artifact federation

1. Stop the iGateway service.
2. Locate and open the iPoz.conf file from the following location:
   • Windows

     %IGW_LOC%

   • UNIX or Linux

     /opt/CA/SharedComponents/iTechnology

3. Edit the following tag:

   <ArtifactManager SessionTimeout="10" RequestTimeout="30"ArtifactStore="local/federated"></ArtifactManager>
   

   • Where
   • SessionTimeOut

     Specifies the expiry time in minutes for an exported session.

     Default: 10 minutes

   • RequestTimeOut

     Specifies the expiry time in minutes for a launch request.

     Default: 30 minutes

   • Store

     Specifies the storage location of artifacts. If the value is mentioned as local, the artifacts from one CA EEM Server are not available on other CA EEM Servers in the failover setup. For artifacts to be available on all CA EEM Servers, set the value for this parameter as federated.

     Value: [local | federated]

     Default: local

   Note: The SessionTimeOut and RequestTimeOut parameters are also present in the eiam.conf file. If you specify these parameters in the eiam.conf file, the values from eiam.conf file take precedence.

4. Save and close the file.
5. Start the iGateway services.

   The artifact federation is enabled.