How to Configure the Deployed Product Data Sets

The deployed product data sets must be configured to enable you to start and customize the product.

To prepare the deployed files, complete the following steps:

1. To edit the members of the iprfx.iqual.CSIQJCL data set, you customize the BC1JJB03 member to the naming conventions in effect at your site. Then submit the job for execution to perform global change commands against several of the deployed source libraries.

   Note: The BC1JJB03 job performs global edits against some of the SMP/E runtime (deployed) libraries. BC1JJB03 uses the CA Endevor SCM program SCMUPDTE to make these edits. The SCMUPDTE program can run in report or update mode. For more information about SCMUPDTE, see SCMUPDTE Program.

2. Make iprfx.iqual.CSIQJCL data set members SCMM@LIB and SCMM@SYM available to CA Endevor SCM jobs at runtime.
3. Authorize the load module libraries.

Note: A client with an existing installation may want to run their current release and the new release on the same system/LPAR. In this case, the client must verify that the libraries for the new release cannot be used by accident. For more information, see Concurrent Releases.