EP003

VERIFY SERIAL dtfname SYSnnn=cuu volser

Reason:

One of the following is true: the tape assigned by JCL or selected by the operator is not a CA EPIC for z/VSE tape or the tape is CA EPIC for z/VSE-controlled but is unlabelled.

The operator is asked to verify that the volume detected on the VOL1 label is the correct volume. The system waits for an operator response.

dtfname is the program DTF used for this tape request.

SYSnnn is the programmer logical unit used for this tape assignment.

cuu is the tape drive address of the mounted tape.

volser is the serial number of the mounted tape.

Action:

Do one of the following:

To accept volser, use (ENTER).
To specify another volume, enter another volume serial number.
To cancel the job, use CANCEL.

Email CA Technologies about this topic