Administration Guide › Set Up Replication › Multiwrite Replication › Enable Multiwrite Replication › Display the Multiwrite Status of a DSA

Previous Topic: Include a DSA in a Multiwrite Group

Next Topic: Prevent Multiwrite Queues Being Lost When the DSA Stops
Display the Multiwrite Status of a DSA

The get dsp console command shows the current DSP configuration values of the DSA.

The output of this command displays the following, if they exist:

To display the multiwrite status of a DSA, enter the following command on a DSA console:

get dsp;

More information:

get dsp Command—Display the DSP Configuration Values

Configure Multiwrite Replication