Administration Guide › Manage Bindings › Closing Bindings › Abort All Bindings

Previous Topic: Closing Bindings

Next Topic: Abort One Binding

Abort All Bindings

You normally only abort all bindings as a prelude to stopping the DSA. In this case you may want to disable new bindings to the DSA before you abort all bindings.

To abort all bindings

  1. Use Telnet to connect to the DSA on which you want to abort all bindings.
  2. Use the following command: 
    abort all-users;

More information:

set allow-binds Command—Enable or Disable New Bindings on a DSA

abort Command—Close Bindings