The following table lists the port numbers used by the CA Directory components in a default installation.
Each DSA you create will take up at least one additional port number.
You can use the get stack command to see the port numbers used on a DSA.
Component |
Protocol |
Port Number |
Description of Port |
Accepts SSL Requests |
Configuration |
---|---|---|---|---|---|
DXwebserver |
TCP |
8080 |
DXwebserver listens on this port for non-SSL connections. |
No |
Change DXwebserver's Port Numbers
|
TCP |
8443 |
DXwebserver listens on this port for SSL connections. This is also used for the Coyote/JK2 1.3 connector port. |
Yes |
||
TCP |
8005 |
DXwebserver listens on this port for the shutdown command. |
Yes |
||
DXadmind |
TCP |
2123 |
This port is used for LDAP communication between DXadmind and DXmanager. |
No |
This port number is not configurable. |
TCP |
2125 |
DXadmind uses this secure LDAPS port to monitor remote DSAs. A user name and password are required, and connections are only accepted from trusted computers. |
Yes |
This port number is not configurable. |
|
DXtrap Sample Tool |
TCP |
162 |
DXtrap receives SNMP traps on this port. For more information, see the Readme in DXHOME/samples/trap. |
|
|
Copyright © 2011 CA. All rights reserved. | Email CA Technologies about this topic |