Reference › Other Commands › DXadmind Commands

DXadmind Commands

DXadmind is a background process that runs on each host that contains a DSA. DXmanager uses DXadmind to communicate with the DSAs. The DXadmind on each host collects information for DXmanager and manages the DSAs on that host on behalf of DXmanager.

The CA Directory installation process installs dxadmind, so dxadmind is started each time the operating system starts up.

If you are having problems with DXmanager, you may need to monitor, start, or stop DXadmind.

The syntax is as follows:

dxadmind command

command

Specifies the command and is one of the following:

debug [level] [local]

Start the service in debug mode.

help [local]

Display basic configuration information.

install name

Install the service instance specified.

remove [name]

Uninstall the dxadmind service on the local host.

setup trustedhost port [password]

Write an empty config file with the port, trusted host, and password.

start [name]

Start the dxadmind service.

status [name]

Display the status of the dxadmind service.

stop [name]

Stop the dxadmind service.