Reference › DSA Commands (DXserver Commands) › Commands Reference › set multi-write-dsp-idle-time Command

Previous Topic: set multi-write-disp-recovery Command - Enable Multiwrite-DISP Recovery

Next Topic: set multi-write-error-trap Command

set multi-write-dsp-idle-time Command

The set multi-write-dsp-idle-time command sets the idle time on links between multiwrite peer DSAs. If you do not use this command, the value in the set dsp-idle-time command is used instead.

This command is no longer required, because each DSA is now multi-threaded. However, it is still supported, for backward-compatibility.

This command was useful for when the DSP idle time was set to a very low value. This could cause the link between a multiwrite DSA and its recovering peer DSA to time out before the DSA was recovered.

This command has the following syntax:

set multi-write-dsp-idle-time = time;
time

Specifies the idle time (in seconds) for links between multiwrite DSAs.