Integration Guide › Integrate an Eracom HSM › Configure the HSM › Update the HSM Configuration Files › Update the Inactive IP Tables

Update the Inactive IP Tables

Before the IP tables are completely configured, it should have an inactive table defined. This is less critical as there is very little running in the operating system by the time the inactive table is loaded. The following set of commands provides you with a suitable inactive table.

iptables -F INPUT
iptables -F OUTPUT
iptables -F FORWARD
iptables -A INPUT -j DROP
iptables -A OUTPUT -j DROP
iptables -A FORWARD -j DROP
/etc/init.d/iptables save inactive

Once the last command is entered, the HSM should respond with the following message.

Savinging iptables ruleset: save "inactive" with counters