Previous Topic: Force a DSA to Stop Using a Command Line

Next Topic: Check the Status of a DSA by Using a Command Line

Refresh a DSA Using a Command Line

If you reinitialize a DSA, it checks its configuration files and applies any changes without stopping and restarting.

To reinitialize a DSA using a command line

  1. Open a command line with the appropriate user permissions.

    On UNIX, use DSA user.

    On Windows, use Control User or Super User.

  2. Enter the following command:
    dxserver init dsaname | all
    


Copyright © 2009 CA. All rights reserved. Email CA about this topic