Previous Topic: Setting Up Static Directory Roles

Next Topic: Disable Static Roles

Enable Static Roles

Before you can create static roles, you must set up static groups. Ensure that groups are working without error before you set up roles.

A static group becomes a static role when the set use-roles = true command is used.

To enable static roles

  1. Stop the DSA.
  2. Specify the subtree that stores the group entries by including the following commands in the DSA's configuration:
    set role-subtree = dn;
    set use-roles = true;
    

    In this command, dn is the distinguished name of the subtree used to store the group entries.

  3. Start the DSA.

More information:

set role-subtree Command

set use-roles Command


Copyright © 2009 CA. All rights reserved. Email CA about this topic