Previous Topic: Create Democorp DSAs on the New Hosts

Next Topic: Create a Router DSA on Each Host

Create UNSPSC DSAs on the New Hosts

You have now created Democorp DSAs on all hosts. You should now create a UNSPSC DSA on each host.

To create UNSPSC DSAs on the new hosts

  1. Navigate to the Topology map.
  2. Right-click a host, select the select Instantiate a new partition to this host, and then select As a Data DSA.

    The New Relationship dialog opens.

  3. Select the UNSPSC option in the Namespace list.
  4. Click Next, and then review the list of network addresses for this host. If the list is correct, click Finish.
  5. Repeat these steps for the other two hosts.
  6. Save this version of the configuration, as follows:
    1. Click Configuration, Save.
    2. Enter a comment that describes the current state of the configuration, and then click OK.

    You have now created configuration for all three DSAs in this backbone.


Copyright © 2009 CA. All rights reserved. Email CA about this topic