Integration Guide › Integrate an Eracom HSM › Install the Eracom Win32 Software › Confirm Software Installation

Confirm Software Installation

After the installation of the two packages, you should be able to confirm installation of the Eracom client utilities.

To confirm that the Eracom client utilities were installed

1. Open a command prompt
2. At the command prompt, enter in the following command:

   hsmstate
   

   The following output appears:

   hsmstate
   HSM device 0:   HSM in NORMAL MODE. RESPONDING
   

3. Enter the following command:

   ctconf
   

   The first time you run this command you will be asked to set the pin for two roles, Admin and Administrator.

   Select pins for both roles.

4. Enter the ctconf command again.

   The following output appears, demonstrating that the client utilities installed on the directory host are communicating with the Eracom HSM:

   ProtectToolkit C Configuration Utility $Revision: 1.129 $
   Copyright (c) Eracom Technologies 2003
   Current Adapter Configuration for Device 0:
   Model             : 8000:PL450
   Serial Number     : 4133
   Adapter Clock     : 15/06/2006 02:40:26 (+10:00)
   Battery Status    : GOOD
   Security Mode     : Default (No flags set)
   Transport Mode    : None
   FM Support        : Enabled
   FM Status         : No FM downloaded yet
   Open Session Count: 0
   Number of Slots   : 1
   RTC Adjustment Access Control: Disabled
   PLEASE NOTE that the firmware allows FMs to be downloaded; but the "Tamper before upgrade" security flag is not set. To protect existing keys against a possible threat of a rogue FM, this flag should be set (using 'ctconf -ft')