Previous Topic: Commands Deprecated in r12 SP2

Next Topic: Features No Longer Supported

Commands Made Obsolete By DXmanager

The following table lists the commands that are now obsolete if you are using DXmanager to configure DSAs. These commands are still valid if you are not using DXmanager.

Command

Reason

Side-effect

always-chain-down

Automatically set to TRUE when using DXmanager configuration

Critical alarm and DXserver shutdown

authentication

Derived when using DXmanager configuration - the minimum authentication level of all DSAs in the grid

Critical alarm and DXserver shutdown

cache-attrs

All attributes are cached for DXgrid

Critical alarm and DXserver shutdown

cache-load-all

Set to true for DXgrid

Critical alarm and DXserver shutdown

dxconsole-connect-alert

Set via DXmanager

Critical alarm and DXserver shutdown

dxgrid-db-location

Set by DXmanager configuration

Critical alarm and DXserver shutdown

lookup-cache

Set to true for DXgrid

Critical alarm and DXserver shutdown

min-auth

Derived when using DXmanager configuration - the minimum authentication level of all DSAs in the grid

Critical alarm and DXserver shutdown

multi-casting

Automatically set to TRUE when using DXmanager configuration

Critical alarm and DXserver shutdown

multi-chaining

Automatically set to TRUE when using DXmanager configuration

Critical alarm and DXserver shutdown

multi-write-dsp-idle-time

No longer required in r12 due to architectural DXserver changes

Still supported

multi-write-disp-queue

Set via DXmanager

Critical alarm and DXserver shutdown

multi-write-disp-recovery

Set via DXmanager

Critical alarm and DXserver shutdown

 

 

 

multi-write-notify

No longer required in r12 due to architectural DXserver changes

Still supported

multi-write-queue

Set via DXmanager

Critical alarm and DXserver shutdown

multi-write-serial

Set via DXmanager

Critical alarm and DXserver shutdown

set dsa (knowledge)

Set via DXmanager with the following knowledge set as default:

  • multi-write-group = "region name"
  • load-share-group = "site name"
  • dsa-flags = no-service-while-recovering - always enabled for data DSAs
  • dsa-flags = load-share - always enabled
  • precedence & write-precedence - cannot set explicit ordering. DSA will order by current region first.
  • trust-flags = allow-downgrading, allow-upgrading - set automatically based on authentication level.
  • trust-flags = no-server-credentials - set automatically if a non-X500 DSA.

Still supported for legacy DSA instances

wait-for-multiwrite

Set via DXmanager

Critical alarm and DXserver shutdown


Copyright © 2009 CA. All rights reserved. Email CA about this topic