Installing Your Product from Pax-Enhanced ESD › How to Install Products Using Native SMP/E JCL › Prepare the SMP/E Environment for Pax Installation

Prepare the SMP/E Environment for Pax Installation

The members used in this procedure prepare the data sets, initialize the zones, and create the DDDEFs for CA Datacom/AD.

Prior to beginning this procedure, confirm whether your product uses UNIX System Services (USS). If it does, establishing a hierarchical file system (HFS) may be required as part of the product installation or required as a feature of the product.

The procedure to prepare the SMP/E environment for your product follows.

Follow these steps:

1. Customize the macro AAXSEDIT with your site-specific information and then copy the macro to your SYSPROC location. Replace the rightmost parameters for each ISREDIT CHANGE macro command. Each time you edit an installation member, type AAXSEDIT on the TSO command line, and press Enter to replace the defaults with your specifications.

   If your product requires HFS or if you want to install a feature of the product that requires HFS, follow the instructions in the AAXSEDIT to optionally install the USS function. The person who installs the USS component must have SUPERUSER authority for the HFS environment.

   The macro is ready to customize the yourHLQ.CAI.SAMPJCL members.

   Note: Set the DASD HLQ to the same value specified for yourHLQ for the unzip to DASD ESD JCL.

   Note: The following steps include instructions to execute the AAXSEDIT macro each time you open a new SAMPJCL member. To edit all SAMPJCL members simultaneously, read and follow the instructions in the AAXEDALL member.

2. Open the SAMPJCL member AAX1ALL in an edit session and execute the AAXSEDIT macro from the command line.

   AAX1ALL is customized.

3. Submit AAX1ALL.

   This job produces the following results:

   • The target and distribution data sets for CA Datacom/AD are created.
   • Unique SMPLTS, SMPMTS, SMPSCDS, and SMPSTS data sets for this target zone are created.
4. Open the SAMPJCL member AAX2CSI in an edit session and execute the AAXSEDIT macro from the command line.

   AAX2CSI is customized.

5. Submit AAX2CSI.

   This job produces the following results:

   • The CSI data set is defined.
   • The SMPPTS and SMPLOG data sets are allocated.
   • The global, target, and distribution zones are initialized.
   • The DDDEF entries for your product are created.
   • The DDDEFs for the required SMP/E data sets are created.
6. If your product requires HFS or if you want to install a feature of the product that requires HFS, complete the following substeps: The person who installs the USS component must have SUPERUSER authority for the HFS environment.
   1. Open the SAMPJCL member AX22MKD in an edit session, and execute the AAXSEDIT macro from the command line.

      AX22MKD is customized.

   2. Submit AX22MKD.

      This job allocates your HFS data sets, creates all directories, and mounts the file system.

   3. Open the SAMPJCL member AX23CSIU in an edit session, and execute the AAXSEDIT macro from the command line.

      AX23CSIU is customized.

   4. Submit AX23CSIU.

      This job customizes the CSI by adding the DDDEFs associated with the directory.