Deployment Guide › Third-Party Integration › EMC SourceOne Integration › Configure the SourceOne Archive Agent

Configure the SourceOne Archive Agent

After installing the SourceOne archive agent, no further configuration is necessary.

But if you subsequently need to designate a different SourceOne server or you want to change the logging level, you can modify values in this registry key on the RDM server and SourceOne management server:

HKEY_LOCAL_MACHINE\Software\ComputerAssociates\CA DLP
  \CurrentVersion\EMCSourceOneAdapter

Within this key, edit the following registry values:

DMSServer

Type: REG_SZ

Machine: Edit this registry value on the RDM server only.

Data: Set this to the name or IP address of the SourceOne host machine (that is, the DMS server).

The RDM needs to be able to identify the SourceOne host machine. If, at any point, this machine changes after you install the RDM, edit this registry value to specify the new host machine.

LogLevel

Type: REG_DWORD

Machine: Edit this registry value on the RDM server and on the machine hosting the SourceOne archive agent (this is the SourceOne management server).

Data: Defaults to 2. This determines the level of logging for message processing. For example, you can configure the archive agent to only log errors or important system messages.

Log entries are written to wgnemcs1_<date>.log where <date> is the date and time when the log file was created. The supported logging levels are:

1 Errors only

2 Errors and warnings

3 As 2, plus informational and status messages