CA-L-Serv › Configure VTAM Communication › Start the Communications Server with VTAM

Previous Topic: Configure VTAM Communication

Next Topic: Start the Communications Server with XCF and VTAM

Start the Communications Server with VTAM

If you plan to use a VTAM protocol only, issue the ATTACH command as follows:

ATTACH COMMSERVER ACBNAME(name) CONTYPE(luvalue)
name

Defines the applid that identifies CA-L-Serv to VTAM on this system. See the chapter "Starting CA-L-Serv" in the Installation Guide for instructions on setting the value of applid.

luvalue

Either LU0 (for LU 0) or LU62 (for LU 6.2). If CONTYPE is not specified, it defaults to LU0.