Troubleshooting › Identify and Resolve the Problem › ENF/DB2 Troubleshooting Checklist

ENF/DB2 Troubleshooting Checklist

The following items may help you identify the problem.

1. Is the CAW0LOAD in the MVS LINKLIST or STEPLIB concatenation?

   Add it if it is not.

2. Is the proper ENF/DB2 intercept module present in CAW0LOAD?

   The load module is CASR230.

3. Is the CA application initialization module (CADB2INT) available to ENF through the STEPLIB or LINKLIST?

   If it is not, make it available.

4. Are the CAS9800I and CAS9801I initialization messages issued?
5. Are all required DCMs present (installed) in the ENF startup procedure?

   If a required DCM is missing, install it into the database. Some frequently used DCMs are: CAS9DCM0 and DB10DCM1. Note that the DCM supplied by the CA security products is the same one.

6. Is the intercept module being loaded?
   • Check for the DB2REL statement in ENFPARMS.
   • Check MVS storage. Is it "Go to address EVT+430???."? The ??? means there are three levels of indirect addressing. It should point to the vector table, and the first CSECT should be at +X'70'.

     Note: You can get the EVT address by issuing the ENF MAP command.